VIVO driver installation and using video capture

A. Video in driver installation
[Note: It is necessary to install graphics card driver before installing VIVO driver. This following procedure is only applicable to VIVO enabled graphics card]

1. Click [Video In Drivers]


2. Click [Next]


3. Click [Next]




4. Click [Finish]


5. Click [Next]




6. Click [Finish]


7. Click [Next]




8. Click [Finish]


9. Click [Next]




10. Click [Finish]


11. Click [Control Panel] --> [System]


12. Click [Hardware] tab

13. Click [Device Manager]


14. If the Video In Drivers are installed properly, the device manager will display


at

B. Capture video with “Power Director” software (Capture video from DVD Player through S-Video Cable in this example)

1. Connect the DVD Player to the display card with correct cable

2. Run the Power Director
3. Click [Capture Mode] at



4. Click [Analog Video Capture] at


5. Click [Video Setup] at


6. Select the correct capture source (Select Video SVideo in this example)


7. Click [Record] to start recording the video


8. Click [Stop] to stop recording the video


9. Enter the captured file name and then click [OK]


10. You can edit and make your own movie with the Power Director software (At the Help of the Power Director will guide the user how to create the movie)


11. Finally, your own movie will be stored at the pdwork folder